I have tried to write multiple lines in a single TEXT but they just overwrite each other on the same line. But, I know there are zebra commands to do that but where do I put them? The free attributes section with S_LZPL_SETUP?Ĥ. ![]() Most solutions on SDN say to put in a second line with the readable value. I would like to print the text of the barcode underneath the actual barcode. into the free attributes section of a Smartform COMMAND but that didn't work so used print controls (described in the thread above). I tried to send zebra commands the way Zebra described by putting S_LZPL_SETUP = ^. I can see in SPAD that there are 'printer initialisation, end of line. Currently, I send a ^FWN at the end of the form to make sure that it is reset for the next print out: When I send a ^FWR print control to the Zebra, it is stored in memory and hence effects the next text that is output - even if that is a completely new print out. (Should I create multiple threads for these?)ġ. ![]() They have all been asked before but the answers seem to vary. These are a few questions related to the thread [SDN Zebra question| Zebra printing S_LZPL_SETUP = ^FWR & ^LRY.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |